The introduction of CNC machines – this is a complex event in which the adjustment is one of the stages in the organization of their operation. The preparation of these tools for commissioning by the example of multistage machine (MS) with NC. Specificity adjustment of CNC is that during the operation must periodically (during the transition to the processing of each new piece) to configure the necessary characteristics of hydraulic pneumatic, mechanical parts, electrical apparatus, electronic devices, power machines, automatic control systems, variable speed drives innings. Performing adjustment machine adjuster uses a map in which shows the initial data for setting instruments (their length and radius) and accessories. If the processing required to provide the 8th (and more) Kvalitet precision adjustment of the processing is carried out by the first blank test passes. In the process of setting up of electronic and electrical equipment control systems of CNC machines is carried out oscillograms of voltage and waveform, as well as transients. Adjustment of CNC devices (CNC) performed successively on each device unit, a node (eg, reader, input, arithmetic unit, display unit, interpolation, memory, speed of assembly tasks, etc.) without changing the schema node, block, devices are the optimal values of output signals, ensuring accuracy and efficiency of the device as a whole. Adjustment is done with the help of tuning elements provided for in the design, pattern blocks, node device (eg, variable resistor), or by choosing any of the elements of the scheme, affecting the output parameter. In the performance of CNC commissioning due to various, conducted at the control points measurements, which resulted in estimated output parameters of the host unit and the unit as a whole.
Archives
- February 2025
- December 2024
- November 2024
- March 2024
- August 2023
- January 2023
- June 2022
- November 2020
- July 2020
- June 2020
- May 2020
- April 2020
- March 2020
- February 2020
- January 2020
- December 2019
- November 2019
- October 2019
- September 2019
- August 2019
- July 2019
- June 2019
- May 2019
- April 2019
- March 2019
- February 2019
- January 2019
- December 2018
- November 2018
- October 2018
- September 2018
- August 2018
- July 2018
- August 2017
- July 2017
- June 2017
- April 2017
- March 2017
- February 2017
- December 2016
- November 2016
- October 2016
- August 2016
- July 2016
- March 2016
- February 2016
- January 2016
- December 2015
- November 2015
- October 2015
- September 2015
- August 2015
- July 2015
- June 2015
- April 2015
- March 2015
- February 2015
- January 2015
- December 2014
- November 2014
- October 2014
- September 2014
- August 2014
- July 2014
- June 2014
- May 2014
- April 2014
- March 2014
- February 2014
- January 2014
- December 2013
- November 2013
- October 2013
- September 2013
- August 2013
- July 2013
- June 2013
- May 2013
- April 2013
- March 2013
- February 2013
- January 2013
- December 2012
- November 2012
- September 2012
- July 2012
- April 2012
- January 2012
- December 2011
- November 2011
- October 2011
- September 2011
- August 2011
- July 2011
- January 2011
- September 2010
Categories
Pages